MC-2010MN
Minimum use conditions:
Wall/slab thickness greater than 9.0"
Pipe diameter greater than 24"
Will withstand high hydrostatic head
Clean pipe and attach with glue.
MC-2005T
Minimum use conditions:
Wall/slab thickness greater than 9.0"
Pipe diameter
greater than 4.0" and
less than 24.0"
Will withstand high hydrostatic head
Peel and stick (add additional glue to pipe if
necessary)
P-201
Minimum use conditions
Wall/slab thickness greater than 4.0"
Pipe diameter
greater than 4.0" and less than 24"
Attach with glue
Hydrostatic head less than 25 feet
KBA-1510FP
Minimum use conditions
Wall/slab thickness greater than 4.0"
Pipe diameter
greater than 4.0" and less than 24"
Attach with glue
Hydrostatic head less than 25 feet
CONSTRUCTION JOINTS / COLD
JOINTS(products encapsulated in
concrete)
Non-moving below grade or water
exposed cold joints
MC-2005M
pre-formed rubber strip
20mm X 05mm
(0.79" X
0.20" - 3/4" X 3/16")
(embedded wire mesh)
Minimum Use Conditions:
Wall/slab thickness greater than 9" and less than 24" (Minimum 4" concrete coverage) - 6.5 ft wall height (check with representative for variations)
Between double row of rebar
Below grade or water present either side of wall/slab joint
Hydrostatic head less than 50 feet
Benefits:
Withstand intermittent exposure to rain or water
Expands up to 2 times by volume
Embedded wire mesh promotes vertical expansion vs longitudinal
Attach with glue or P-201 (may need screws with P-201)
Can be used on rough concrete with P-201
MC-2010MN
pre-formed rubber strip
20mm X 10mm
(0.79" X 0.39" - 3/4" X 3/8")
(embedded wire mesh )
Minimum Use Conditions:
Wall/slab thickness greater than 9.0" (10.0" recommended) Minimum 4" concrete coverage - 6.5 ft wall height (check with representative for variations)
Between double row of rebar
Below grade or water present either side of wall/slab joint
Benefits - "NSF CERTIFIED":
Withstand high hydrostatic head
Withstand intermittent exposure to rain or water
Expands up to 2 times by volume
Embedded wire mesh promotes vertical expansion vs longitudinal
Attach with screws, nails, glue, P-201 (may need nails or screws with P-201)
Can be used on
rough concrete with P-201
NSF
approved for potable water
KBA-1510FP
pre-formed rubber strip
15mm X 10mm
(0.59" X 0.39" - 9/16" X 3/8")
Minimum Use Conditions:
Wall/thickness greater than 4.0" (Minimum 1" concrete coverage
Can be used with single row of rebar or double row of rebar
Below grade or water present either side of wall/slab joint
Hydrostatic head less than 25 feet
Benefits:
Can be used outside of rebar
Low expansion pressure can be used with limited concrete coverage (1.0")
Expands approximately 25% by volume
Attach with glue or P-201 (may need screws with P-201)
Use in containment dikes
